Featured Products

Formaldemeter htV-m
NEW DATA LOGGING PORTABLE FORMALDEHYDE MONITOR
The Formaldemeter htV-m is a direct-reading portable formaldehyde monitor with built-in memory for continuous stand-alone monitoring and storage of up to one month of data. Data can be downloaded directly to a PC without the need for additional hardware. The htV-m can be connected directly to a PC via an RS-232 link for programming various sampling and data collection options. The htV-m can be battery operated or powered by 110/220 VAC mains. Other features of the htV-m include monitoring of temperature and relative humidity. The standard range is 0 to 10.00 ppm formaldehyde. The htV-m kit is supplied with an instruction manual, calibration standard, power supply, RS-232 cable and software.

PGD3-IR PORTABLE MULTI-GAS DETECTOR
The model PGD3-IR portable multi-gas detector incorporates an infrared combustible gas sensor for 0-100% LEL or 0-100% by volume methane, and an infrared sensor for carbon dioxide at various optional ranges from ppm concentrations to 100% by volume CO2. In addition, the PGD3-IR can also be supplied with an oxygen sensor or electrochemical sensors for various toxic gases, such as, CO, H2S, NO2, SO2, etc. The instrument has audio/visual alarms and complete data logging capability. Other features include a rugged enclosure with protective rubber boot for IP66 rated impact and water resistance. The PGD3-IR is ATEX certified and CE approved.

MATRIX
Medical Gas Verifier Monitor
ENMET’s “MATRIX” medical gas verifier monitor represents over 35 years of experience in the design and manufacturing of gas and vapor monitoring instruments. This multi-sensor system has detection capabilities to simultaneously monitor carbon monoxide, carbon dioxide, oxygen, methane, nitrous oxide, trace hydrocarbons, anesthesia gases, and dew point. The transportable device weighs 15 lbs and has a rechargeable power pack. The internal lithium ion power supply has been shown to deliver over 10 hours of continuous operation for the fully operating multi-sensor instrument. The front panel presents two each 4-gas displays for the two master printed circuit boards within the instrument. After a warm up time of less than 5 minutes, 4 different gases can be measured by each half of the MATRIX for a total of eight. Matrix is now in pilot production phase at ENMET’s facility in Ann Arbor, Michigan.

EX-5165 CARBON DIOXIDE SENSOR/TRANSMITTER
The EX-5165 Sensor/Transmitter features an infrared sensor which can be supplied calibrated for the detection of carbon dioxide in ranges available from 0-500 ppm to 0-100% by volume CO2. The NDIR sensor can continuously monitor high concentrations of CO2 and operate in an anaerobic environment. This sensor/transmitter provides an LCD of the gas concentration and has three LED alarm point indicators. It is approved for location in Class I, Division 1, Groups B, C and D atmospheres. It features a liquid crystal display, 4-20 mA output and non-intrusive calibration. The EX-5165 is a 24 VDC loop powered transmitter that provides a 4-20 mA output which can be connected to a PLC or any one of several controllers available from ENMET Corporation.